Băng nối SMD Tape

SMD Double Splice Tape for 8 mm Component Tapes. No down times because of accurate joining. Tape Connectors guarantee perfect and reliable joints in 8 mm SMD tapes. Joining without any tools or fixtures, with precise pitch spacing, with convenient pre-cut length. Siemens AG developed and patented the SMD Double Splice Tape. It is supplied in short length, ready for use.

After peeling off the upper tape the raised dots of the clear plastic carrier engage with the sprocket holes and align the SMD tape ends perfectly with each other and the joining tape. The first adhesive tape then joins up the SMD cover tape ends. The perforated centre line of the carrier, later to be discarded, helps in folding the connector around the component tape, providing further alignment and joining from the other side. SMD Double Splice Tape can also be supplied in continuous lengths for individual cutting on site.

SMD cover tape extenders have been developed to enable pick and place machine users to use component tapes in full reels or short sections, without any available leader, and not waste a single component. The tape extender gives you over 15 inches of non-adhesive film to start through the tape feeder. Removing the cover paper reveals the adhesive side of the yellow tape, whose mark is aligned with the front edge of the component tape and stuck unto its cover tape. The non-adhesive, transparent end of the Polyester foil strip can now be fed into the tape feeder. There is enough length available (over 15 inches) not to have to discard components in the process. The bond between the tape extender and the original cover tape is sufficient to ensure that they will not separate, even after prolonged time under tension. Three widths are available and packed in special cartons.