Epoxy Resin FLOORING

AREA OF USES

ADVANTAGES

INTRODUCTION

Rockmax Supercote SL is a two components 100% solid epoxy resin floor topping. This product provides a high gloss, smooth, seamless, hygienic, durable and hard wearing. Rockmax Supercote SL designed for application 1-3mm thickness and suitable with industrial and commercial application.

APPLICATION AND INSTALLATION

PREPARATION

New concrete substrate
Concrete must be sound, clean and free from cement paste, dust, dirt and any other contaminants. Concrete must be at least 28 days and minimum Compressive strength 25N/mm2 and minimum tensile strength (pull off) at 1.5 N/mm2. Moisture content in concrete must less than 4%. All floors to received Rockmax Supercote SL topping should be protected by damp proof membrane. Total enclosed shot blasting or scarifying should be employed followed by vacuuming.

Old concrete (Uncoated concrete)
Old concrete or uncoated concrete floors is done in much similar manner to new concrete preparation. The concrete surface must be thoroughly cleaned with a strong detergent cleaner to remove all grease, oils and etc. Holes and cracks must be repaired use epoxy injection and epoxy mortar (please consult Rockmax for more information).

Previously coated concrete surface
Existing coated surface must be completely removed by sand blasting until received sound surface. Clean all surface with detergent cleaner. Total enclosed shot blasting or scarifying should be employed followed by vacuuming.

PRIMING

Apply Rockmax Supercote P at 1 or 2 coat. Allow to dry prior to application. Please refer Rockmax Supercote P datasheet.

MIXING

Stir each component separately approximate ½ to 1 minute. Mix part A and part B approximate 3 minutes until homogeneous using electric mixer (400-500 rpm). Avoid whipping air into the material. It is recommended that only full units be used, that both components are thoroughly mixed. We do not recommend using partial kits and reduce material.

APPLICATION

This material must be applied by specialist trained applicator. Pour mixed material directly on the surface in a long puddle and spread using either trowel or rubber squeegee. Pull through material until end of joints. Pour new material on to end of joints to maintain wet edge. Check film thickness frequently. Use spike roller to remove any entrapped air. Do not spike roller after 30 minutes.

CURING

Protect applied areas from foot traffic at approximate 24 hours and fully cure in 7 days.

CLEANING

Clean all tools and equipments immediately with acetone, xylene or other solvents.

PACKAGING

20kg set:
Part A: 16kg
Part B: 4kg

EPOXY PRIMER

 

PACKAGING

15 kg set.

 

ROCKMAX SUPERCOTE PS

EPOXY PRIMER FOR STEEL

 

INTRODUCTION

Rockmax Supercote PS is a two components polyamide for protect metal and steel from rust.

AREA OF USES

Primer for Rockmax Supercote 1 & 3 coating on steel and metal.

ADVANTAGES

Anti rust properties.

Good adhesion.

 

 

APPLICATION AND INSTALLATION

PREPARATION

Sound and clean steel surface. Make sure no rust and dust on the surface.

MIXING

Mix part A and part B approximate 3 minutes until homogeneous using electric mixer (400-500 rpm).

APPLICATION

Apply by brush or roller on the prepared surface.

CLEANING

Clean all tools and equipments immediately with acetone, xylene, thinner or solvent.

PACKAGING

15 kg set