HOLIP-HLP-NV

Inverter Series

HLP-NV

Power  supply

Frequency

48～62HZ

Supply Voltage

380~480V±15% for 380V;

200~240V±10% for 220V(single/three phase);

Power output

Output voltage

0~100% of supply voltage

Output frequency

0-400HZ

Over load

150% of rated current

Acc/Dec time

0.05~3600s

Control

Running control

LCP operate;  Multi input terminals;  RS 485 serial communication

Frequency setting

Control terminals

Programmable digital inputs

Number

5, terminal nos.: RUN，F/R，RST，JOG，EMS

Voltage level

0~24V  DC (“PNP” OR “NPN”) ;  Maximum input:28V DC

Logic Voltage level

PNP:“0”<5VDC; “1”>10VDC;

NPN“0” >19VDC; “1” < 14VDC

Input resistance

4KΩ

Analog inputs

Voltage

Number

1;terminal nos.: VIN

Voltage level

0-10V DC ; Maximum input 20V DC

Input resistance

10KΩ

Current

Number

2; terminal nos.: VIN，AIN

Current range

0/4-20mA (scaleable); Maximum input: 30mA

Input resistance

200 Ω

Analog outputs

Number

1;Terminal nos.: AON

Output current range

0/4-20mA

Max. Load

500 Ω

Accuracy

Max. error: 0.5% of full scale

Resolution

8bit

Control terminals

24V DC

Terminal number

EV

Max. load

200mA

RS 485

Terminal number

RS+（TX+,RX+）,RS- (TX-,RX-)

Ground for RS485

COM

Relay output

Terminal number

1,FA-FB(make),FA-FC(break)

Max. load

Resistive load

250V AC 2A

30V DC 2A

Inductive load

250V AC 0.2A

24V DC 0.1A

10V DC output

Terminal number

+10V

Output voltage

10.5±0.5V

Max. load

25mA

Surroundings

Enclosure

IP20

Ambient temperature

-10℃~50℃

Max. relative humidity

5%-95%

Vibration test

1.0g

Max. altitude above sea level

1000m

3000m(derating)

Protection Functions

Electronic thermal motor protection against overload.

Temperature monitoring of the heat sink ensures that the frequency converter trips if the temperature reaches 95 °C ± 5°C. An overload temperature cannot be reset until the temperature of the heatsink is below70 °C ± 5°C (Guideline - these temperatures may vary for different power sizes, enclosures etc.).

The frequency converter is protected against short-circuits on motor terminals U, V, W.

The frequency converter is protected against earth faults on motor terminals U, V, W.

Monitoring of the intermediate circuit voltage ensures that the frequency converter trips

if the intermediate circuit voltage is too low or too high.

If a motor phase is missing, the frequency converter may trip.

If mains fault occurs, the frequency converter will ramp down to stop and issues a warning.

If a mains phase is missing, the frequency converter trips or issues a warning (depending on the load).