http://vh-marine.com/wrap-seal-ultra-pipe-repair-kit-2-x-12-5cm-x-3-6m-9268956.html

Product Description

FEATURES:

• Repairs leak in 30 minutes
• Applicable to pipes up to 18″ (457 mm) diameter
• Applicable on any metal or non-metal pipes
• Repairs T-joint, elbow joint, valve thread, valve body
• Withstand pressure up to 400 psi (28 kg/cm²)
• Withstand temperature up to 200 °C (392 °F)
• Safe for drinking water and resistant to most chemicals
• Reinforce and strengthen pipe after repair
• Permanent repair and extend service life of pipes

CHEMICAL RESISTANCE:

• Oil
• Water (drinking water, wastewater, steam)
• Solvents (acetone, toluene, MEK, ethyl alcohol)
• Mild acids (hydrochloric acid, sulfuric acid) and alkalis
• Chemical (ethylene glycol, xylenes, ammonia)
• Hydrocarbons
• Bases
• Slurries
• Fuels (petroleum, diesels, gasoline)
• Gases (LNG, LPG)
• Organic salts

WORKING TIME (FIBERGLASS TAPE):

• 1 minute at 30 °C (86 °F)

CURING TIME:

• 30 minutes at 30 °C (86 °F)

APPLICATION:

• Pipe repairs: offline repairs, sealing joints, hazardous material spill control, reinforce thinning walls
• Abrasion protection
• Structural reinforcement
• Repairs in hard to reach areas
• Underwater repairs

OPERATING TEMPERATURE:

• Continuous – From -29 °C (-20 °F) up to 200 °C (392 °F)
• Intermittent – From 200 °C (392 °F) up to 320 °C (570 °F)

OPERATING PRESSURE:

• Recommended for pressure up to 400 psi (28 kg/cm²)
  (Results vary depending on pipe size, type of pipe, hole size, pipe content and method of application)

APPLICABLE INDUSTRIES:
	Building & Facilites		Electronics		Industrial Processing
	Irrigation		Oil & Gas		Chemical
	Manufacturing Plants		Marine		Military
	Petrochemical		Offshore		Food Processing
	Pulp & Paper		Pharmaceutical		Power Generation
	Wastewater		Water Distribution

---

WRAP SEAL ULTRA ACTIVE LEAK REPAIR PROCEDURE

1Minimize the flow rate and reduce system pressure

2Roughen the area to be repaired

3Knead the Seal Stic

 

4Place the Seal Stic away from the leak location

5Start wrapping the SealXpert Ultra Sealing Tape a few distances away from the leak location

6Continue to wrap SealXpert Ultra Sealing Tape onto pipe while pushing the Seal Stic onto leak location

 

7Immerse Wrap Seal Fiberglass Tape into water

8Wrap the Wrap Seal Fiberglass Tape above the repair tape as tightly and evenly as possible, using the entire roll

9Discard the plastic tube at the end of the roll

 

10Wet gloves in water and quickly compress the bubbling resins back into the fiberglass wrap until all bubbling has stopped. Repair completed with smooth and hard ivory appearance

Sản phẩm doanh nghiệp: Công ty TNHH TMDV Kỹ Thuật Đầu Tư Việt Hà